Grand Prix V6-191 3.1L VIN M SFI (1998)
5. Disconnect the master cylinder brake pipes (1 ) from the BPMV (2).
6. Remove the two nuts (1) that connect the BPMV to the BPMV bracket.
NOTICE: When removing the brake pressure modulator valve, protect vehicle exterior from possible brake fluid spillage.
7. Remove the BPMV (2) and EBTCM as an assembly from the vehicle.
8. Remove EBTCM if replacing the BPMV only.
INSTALLATION PROCEDURE
1. Install EBTCM if replacing the BPMV only.
2. Install BPMV(2) and EBTCM as an assembly into the BPMV bracket. Align the flats of the studs on the BPMV with the BPMV bracket.
3. Install the two BPMV to BPMV bracket nuts (1).
^
Tighten the two BPMV to BPMV bracket nuts to 12 Nm (8 ft. lbs.).
CAUTION: Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel
lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an
Antilock stop.
IMPORTANT: If a new BPMV is being installed, remove the shipping plugs from the valve openings in the compartment during the next step.
IMPORTANT: Use the locations noted during removal.
