Grand Prix V6-191 3.1L VIN M SFI (1998)
IMPORTANT: Note the location and the orientation of the wave springs in order to aid during installation.
8. If equipped with ABS/TCS remove two wave springs (1) between the EBTCM and BPMV and discard.
INSTALLATION PROCEDURE
IMPORTANT: Only the new wave spring(s) and screws supplied with the new EBTCM should be used.
1. Clean the BPMV gasket surface with alcohol using a clean rag.
2. If equipped with ABS/ETS, install one wave spring (1) between the EBTCM and BPMV. Use location and orientation noted during removal.
3. If equipped with ABS/TCS, install two wave springs (1) between the EBTCM and BPMV. Use locations and orientation noted during removal.
4. Install the EBTCM (1) to the BPMV (5).
^
Tighten the top four mounting screws (2) to 2.9 Nm (26 in. lbs.). Tighten screws in an X pattern.