Grand Prix V6-191 3.1L VIN M SFI (1998)
Shift Cable: Service and Repair
A/T Range Selector Cable Replacement (at PNP Switch)
REMOVAL PROCEDURE
1. Remove the throttle body air inlet duct.
2. Remove the automatic transaxle range selector cable from the wiring harness clip or strap.
CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.
3. Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.
4. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
5. Remove the automatic transaxle range selector cable from the console shift control or the column shift control.
6. Pull the automatic transaxle range selector cable through the dash from the engine compartment side.
INSTALLATION PROCEDURE
1. Insert the automatic transaxle range selector cable through the dash. from the engine compartment side.
CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.
2. Install the automatic transaxle range selector cable to the automatic transaxle range selector cable bracket.
