Grand Prix V6-191 3.1L VIN M SFI (1998)
5. Remove the wiper motor crank arm assembly from the wiper motor assembly.
5.1. Remove the rubber boot from the wiper motor crank arm assembly.
5.2. Loosen the screw.
5.3. Tap on the screw with a soft-faced mallet while holding up on the wiper motor crank arm assembly until the wiper motor crank arm assembly
is loose on wiper motor assembly.
5.4. Remove the screw and wiper motor crank arm assembly from wiper motor assembly.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J 39529 Wiper Transmission Installer.
1. Install the wiper motor crank arm assembly on the wiper motor assembly.
1.1. Install the connector to the wiper motor assembly.
1.2. Turn the ignition switch to the ACCY position.
1.3. Set the wiper switch to the PULSE position. The wiper motor assembly should be operating.
1.4. Turn the ignition off when the wiper motor assembly is in the innerwipe position and not moving.
1.5. Disconnect the connector from the wiper motor assembly.
1.6. Install the wiper motor crank arm assembly on the wiper motor assembly while maintaining a 4-8 mm (0.157-0.314 in) gap between wiper
motor crank arm assembly and bracket tab.
NOTE: Refer to Fastener Notice in Cautions and Notices.
1.7. Install the screw.
1.8. Check the gap between wiper motor crank arm assembly and bracket tab. It the gap is not 4-8 mm (0.157-0.314 in), remove the crank arm
assembly and repeat installation.
Tighten
Tighten the screw to 16 N.m (142 lb in).
1.9. Install the rubber boot onto the wiper motor crank arm assembly.
