Grand Prix V6-204 3.4L DOHC (1992)
FIGURE 2
5.
File radius as shown in Figure 2.
6.
De-burr the inside edges of the handle where the rod fits through, sand all surfaces smooth that were filed.
7.
Touch up all filed surfaces to stop corrosion, this will also insure proper operation.
8.
Reinstall door handle.
9.
Reinstall outside handle to lock rod by adjusting nut on lower end of rod until knob of attaching nut is between one and two turns lower than the
hole in the lever of the lock, snap nut into hole and engage clip onto lever and rod assembly.
10.
Check for proper operation, reinstall water deflector and trim panel.
LABOR OPERATION
: T-1602 Right Side T1603 Left Side
LABOR TIME
: .6 Hour Per Side
