Grand Prix V6-204 3.4L DOHC (1992)
13. Attach bleeder hose to right rear bleeder valve and submerge opposite hose end in clean container partially filled with brake fluid.
Slowly open bleeder valve and allow fluid to flow, then close valve when fluid begins to flow without any air bubbles.
14. Repeat step 13 on left rear wheel brake and then on front wheel brakes.
15. Lower vehicle and remove bleeder equipment.
16. Check fluid level in reservoir and fill to the correct level, if necessary, using clean brake fluid.
17. Install reservoir cover and diaphragm assembly.
Inspect
With ignition "ON," apply brake pedal with moderate force and hold. Note pedal travel and feel.
^
If pedal feels firm and constant and pedal travel is not excessive, start the engine. With the engine running, re-check the pedal travel. If it's still
firm and constant and pedal travel is not excessive, go to step 18.
^
If pedal feels soft or has excessive travel either initially or after engine start. Use the TECH 1, "Release" then "Apply" the motors 2 to 3 times
and cycle the solenoids 5 to 10 times. Now repeat bleeding procedure.
18. Road test the vehicle. Make several normal (non ABS) stops from a moderate speed to ensure proper brake system function.
