Grand Prix V6-204 3.4L DOHC (1992)
Power Steering Line/Hose: Service and Repair
Return Pipe
Power Steering Hose Routing
Remove or Disconnect
1. Coolant recovery reservoir set aside.
2. Serpentine drive belt.
NOTICE: Siphon power steering fluid from reservoir before disconnecting lines to avoid spilling fluid on secondary timing belt cover. Use shop rags
when disconnecting lines to insure any remaining fluid does NOT contact secondary timing belt cover. Power steering fluid can damage the secondary
timing belt.
3. Power steering line clamp at front cover.
4. Power steering return pipe from reservoir hose.
5. Power steering high pressure pipe from pump.
6. Raise vehicle and suitably support.
7. Right front wheel and tire assembly.
8. Loosen right side engine splash shield.
9. Right tie rod nut and tie rod from steering knuckle.
10. Return hose clamp and hose from return pipe.
11. Lower vehicle.
12. Return pipe from vehicle.
Install or Connect
1. Pipe in position.
2. Raise vehicle.
3. Return hose and clamp to pipe, tighten clamp.
