Grand Prix V6-204 3.4L DOHC (1992)
Power Steering Line/Hose: Service and Repair
Cooler Pipe
Power Steering Hose Routing
Tools Required:
J28467-A Engine Support Fixture
J28467-90 Adapters
J36462 Adapter Leg
Remove or Disconnect
1. Air cleaner and duct assembly.
2. Install J 28467-A, J 28467-90 and J 36462.
3. Raise vehicle and suitably support.
4. Left and right wheel and tire assemblies.
5. Electrical connection from steering gear pressure switch.
CAUTION: Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or
intermediate shaft. This damage can cause loss of steering control which could result in personal injury.
6. Intermediate steering shaft pinch bolt at steering gear.
7. Loosen right side engine splash shield.
8. Both left and right sides tie rod nuts and tie rods, from steering knuckle.
9. Exhaust pipe and catalytic converter assembly.
10. Engine and transaxle mount nuts at frame.
11. Power steering cooler line retaining clamps from frame.
12. Support rear frame, using jackstands.
13. Rear frame retaining bolts.
14. Lower frame 76.2 mm (3 inches).
