Grand Prix V6-204 3.4L DOHC (1992)
Power Steering Line/Hose: Service and Repair
Steering Gear Assembly Line (Right or Left)
Power Steering Hose Routing
Tools Required:
J28467-A Engine Support Fixture
J28467-90 Adapters
J36462 Adapter Leg
Remove or Disconnect
1. Air cleaner and duct assembly.
2. Install J 28467-A, J 28467-90 and J 36462.
3. Raise vehicle and suitably support.
4. Right and left front wheel and tire assembly.
5. Electrical connection from steering gear pressure switch.
CAUTION: Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or
intermediate shaft. This damage can cause loss of steering control which could result in personal injury.
6. Intermediate steering shaft pinch bolt at steering gear.
7. Loosen right side engine splash shield.
8. Both left and right sides tie rod nuts and tie rods from steering knuckles.
9. Exhaust pipe and catalytic converter assembly.
10. Support rear of frame, use jackstands.
11. Both rear frame bolts.
12. Lower rear of frame 76.2 mm (3 inches).
13. Steering gear heat shield.
14. Power steering lines clamp from steering gear assembly.
