Grand Prix V6-204 3.4L DOHC (1992)
The automatic door lock system has an actuator in each door which actuates the lock through a linkage. The system is actuated by the chime module in
the convenience center or by any door lock switch. All doors lock or unlock at the same time except when the actuator is manually activated by a lock
rod. Each actuator has an internal circuit breaker which may require on the three minutes to reset.
Remove or Disconnect
1. Door trim panel.
2. Water deflector.
3. Rivets by punching out mandrel, then using a 4.8 mm (3/16) inch drill bit.
4. Clip and electrical connector.
5. Actuator by disengaging from rod.
Install or Connect
1. Actuator to rod.
2. Electrical connector and clip.
3. Rivets using 3/16 inch x 1/4 inch peel type rivets.
Inspect
^
For proper operation by cycling system.
4. Water deflector.
Illuminated Lock Cylinder