Grand Prix V6-204 3.4L DOHC VIN X SFI (1995)
5. Turn throttle body accelerator cam counterclockwise and hold.
-
Remove cruise control cable and slug from idler pulley.
-
Remove accelerator control cable end slug from idle? pulley.
6. Slide cruise control / accelerator control cables from cable bracket, after disengaging locking tabs.
Install or Connect
INSTALL OR CONNECT
NOTICE: To prevent possible interference, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2") of moving
parts, unless routing is positively controlled.
1. Reverse removal procedure.
Inspect
Check for complete throttle opening and closing positions by operating accelerator pedal. Also check for poor carpet fit under accelerator pedal.
Throttle should operate freely without binding between full closed and wide open throttled accelerator cable at engine compartment side of dash
panel.
2. Apply heavy bodies sealer around accelerator cable at engine compartment side of dash panel (bulkhead).
