Grand Prix V6-204 3.4L DOHC VIN X SFI (1995)
Power Lock Actuator
The automatic door lock system has an actuator in each door which actuates the lock through a linkage. The system is actuated by the chime module in
the convenience center or by the door lock switch. All doors lock or unlock at the same time except when the actuator is manually activated by a lock
rod. Each actuator has an internal circuit breaker which may require one to three minutes to reset.
Remove or Disconnect
1. Door trim panel.
2. Water deflector.
3. Rivet by punching out mandrel, then using a 3/16 inch drill bit.
4. Clip and electrical connector.
5. Actuator by disengaging from rod.
Install or Connect
1. Actuator to rod.
2. Electrical connector and clip.
3. Rivets using 3/16 inch x 1.4 inch peel type rivets.
Inspect
^
For proper operation by cycling system.
4. Water deflector.
5. Door trim panel.
Frozen Lock Cylinder Repair
Frozen lock cylinders due to cold weather may be repaired using the following procedure.
NOTICE: Be careful not to damage painted surfaces while using heat gun.
1. Apply heat to cylinder area with a heat gun.
2. Hold shutter door open with a paper clip or similar item and force air into cylinder using compressed air and a blow gun attachment.
3. While holding the shutter door open, inject a small amount of Multi-Purpose Lubricant (GM P/N 12345120) or equivalent, SAE 5W30 Motor
Oil, or spray type Silicone (GM P/N 1052276) or equivalent.
4. Work key into cylinder several times and wipe any excess lubrication residue from the key.
Illuminated Lock Cylinder
