Grand Prix V6-3.1L VIN J (2000)
Passenger Assist Handle: Service and Repair
Assist Handle Replacement (With Lamp)
Assist Handle Replacement (With Lamp)
Removal Procedure
1. Pull down the assist handle and remove the two screws (2).
2. Use a flat-bladed tool to remove the lamp lens.
3. Remove the two lamp screws (3).
4. Pull the handle away from the roof and disconnect the roof rail lamp electric connector.
5. Remove the assist handle from the vehicle.
Installation Procedure
1. Position the rear assist handle to the headliner.
2. Connect the roof rail lamp connector.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the lamps screws (3) assist handle screws (2).
Tighten the lamp and assist handle screws to 3 N.m (27 lb in).