Grand Prix V6-3.1L VIN J (2000)
15.
Lubricate the new caliper pin boots. Use the small packet of grease, P/N 18046645, only on the bottom internal threads (2).
16.
Install the new caliper pin boots into the caliper pin bores (3) on the bracket. Carefully tap boots into bores using a deep well socket or equivalent.
17.
Install the caliper over the rotor and onto the caliper bracket. Ensure that the caliper pin boots are not pinched.
Important:
The leading caliper pin, or top pin, has a bushing as part of the assembly. The trailing caliper pin, or bottom pin, is a solid design.
18.
Install the new caliper pin bolts (1). It is important to note which caliper pin is designed for the correct bore. The leading caliper pin, or top pin,
has a bushing as part of the assembly. The trailing caliper pin, or bottom pin, is a solid design. Ensure that the bolt boots fit securely in the groove
of the pin bolts. Be sure not to pinch or tear the boots. If the boots are damaged, they must be replaced.
Tighten
Tighten the bolts to 95 N.m (70 lb ft).
19.
Remove the 2 wheel nuts retaining the rotor to the hub.
20.
Repeat the above steps for the other side.
21.
Install both the front tire and wheel assemblies. Tighten the wheel nuts using the J 39544 kit.
22.
Lower the vehicle.
