Grand Prix V6-3.1L VIN J (2000)
Engine Mount: Service and Repair
Engine Mount Bracket Replacement
Removal Procedure
^
Tools Required
-
J 28467-90A Engine Support Adapters
-
J 28467-B Universal Engine Support Fixture
-
J 36462-A Engine Support Adapter Leg Set
1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
2. Remove the throttle body air inlet duct.
3. Remove the engine mount struts. Refer to Engine Mount Strut Replacement (Left) or Engine Mount Strut Replacement (Right).
4. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
5. Remove the three-way catalytic converter pipe from the right exhaust manifold. Refer to Catalytic Converter Replacement.
6. Remove the right front wheel and tire.
7. Remove the right engine splash shield.
8. Remove the engine mount bracket-to-oil pan bolts.
9. Install the J28467-90A, the J 36462-A, and the J 28467-B. Refer to Engine Support Fixture. Raise the engine.
10. Remove the engine mount upper nuts.
11. Remove the engine mount bracket from the engine mount.
Installation Procedure
