Grand Prix V6-3.1L VIN J (2000)
EGR Valve: Service and Repair
Exhaust Gas Recirculation (EGR) Valve
REMOVAL PROCEDURE
1. Turn OFF the ignition switch.
2. Disconnect the EGR valve electrical connector.
3. Remove the Bolt retaining the pipe assembly from the EGR valve and carefully pull the pipe assembly back.
4. Remove the EGR Valve retaining bolts.
5. Remove EGR valve assembly.
6. Remove the gasket.
INSTALLATION PROCEDURE
1. Install the EGR Valve with a new gasket to the intake manifold.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Reinstall the Bolts through the EGR valve.
Tighten
Tighten the nuts to 30 N.m (22 lb ft).
3. Connect the pipe assembly to the EGR valve.
4. Reinstall the Bolt.
Tighten
Tighten the nuts to 30 N.m (22 lb ft).
5. Connect the EGR valve electrical connector.
