pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

All Technical Service Bulletins for Alternator: > < Battery - Various Driveability Symptoms
Page 2
background image

supplied with the tester.

5.

If the battery test is OK, recharge the battery and then perform the Charging System test below.

6.

If the test result is REPLACE THE BATTERY, continue with this procedure.

7.

Disconnect both battery cables from the battery.

8.

Clean the battery terminals.

9.

Install the approved battery test adapters.

10.

Retest the battery.

11.

If the REPLACE THE BATTERY result is obtained after the second test, replace the battery and then complete the Charging System test below.

Important:

For warranty purposes, always place the test code displayed by the tester on the repair order. The number is a unique identifier that describes the test
data for a particular battery at a particular time. While the test code may occasionally repeat when testing the same battery, it is more likely that a
different code will result each time the battery is tested.

Charging System Test

Caution:

Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless
instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect
the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Important:

Make sure all electrical loads are OFF. Connect J 41450-B Generator Tester to the generator. Follow the directions supplied with the tester.

If the generator fails the Charging System Test, inspect the coolant fan jumper harness for a part number tag. If the tag shows a P/N 0341, replace the
coolant fan jumper harness with P/N 15371919 (this harness will have a P/N tag of 1919), and the generator P/N 10464415.

Important:

The cooling fan jumper harness branch with the tape marked RH is installed to the passenger side (RH) cooling fan.

If the generator passes the test, use other diagnostic procedures to determine the cause of the customer's concern.

Parts Information

Part Description

Part Number

Generator

10464415

Jumper, Wiring Harness

15371919

Cooling Fans

Parts are currently available from GMSPO.

Warranty Information

For vehicles repaired under warranty, use the table.

All Technical Service Bulletins for Alternator: > < Battery - Various Driveability Symptoms