Grand Prix V6-3.1L VIN J (2000)
10. Remove the jackstands.
11. Install the tie rod ends to the steering knuckle. Refer to Tie Rod End Replacement - Outer.
Important: During the installation of the intermediate steering shaft, ensure the steering shaft is seated before you install the pinch bolt. The two
mating shafts may disengage if the pinch bolt is inserted into the coupling before the steering shaft installation.
Notice: Set steering shaft so the block tooth on the upper steering shaft is at the 12 o'clock position, the wheels on the vehicle are straight ahead and
set the ignition switch to the LOCK position. Failure to follow these procedures could result in damage to the coil.
12. Install the intermediate steering shaft to the power steering gear stub shaft. Refer to Intermediate Steering Shaft Replacement.
13. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
14. Lower the vehicle.
15. Fill the power steering system. Refer to Refilling the Power Steering System.
16. Bleed the air from the power steering system. Refer to Bleeding Power Steering System.
17. Inspect the power steering system for leaks. Refer to Power Steering Gear and Pump Leaks.
18. Remove the drain pan from under the vehicle.
19. Preform a front end alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
