Grand Prix V6-3.1L VIN J (2000)
4. Assemble the following bushing removal tools as shown:
-
J 21474-27
-
J 41014-1
-
J 34126
-
J 35379
-
J 21474-02
-
J 21474-4
5. Tighten the J 21474-4.
6. Disassemble the bushing removal tools.
Installation Procedure
Tools Required
-
J 21474-01 Control Arm Bushing Service Set
Important: The lower control arm vertical bushing MUST be installed in the same position which it was removed in order to maintain the original
vehicle ride, handling and road feel.
1. Align the flat edge of the bushing flange to the mark in the control arm (1). Ensure that the flat edge of the bushing flange is 30 degrees (2) from
the centerline of the lower control arm. Ensure that the thin slot in the bushing is facing outboard.
2. Insert the bushing into the control arm.
Important: Apply J 23444-A (or equivalent high pressure lubricant) to the threads of the J 21474-27.