Grand Prix V6-3.1L VIN J (2000)
4. Position the inboard end of the halfshaft assembly (1) using J 41048.
5. Align the swage ring (2) by performing the following steps:
Notice: Before proceeding, ensure there are no pinch points on the inboard boot (1). This could cause damage to the inboard boot (1).
5.1.
Place the top half of J 41048 on the lower half of J 41048.
5.2.
Insert the bolts.
5.3.
Tighten the bolts by hand until snug.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Align the following items:
^
The inboard boot (1)
^
The housing
^
The swage ring (2)
^
Each bolt 180° at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
5.4.
Loosen the bolts.
5.5.
Separate the dies.
5.6.
Check the swage ring (2) for any "lip" deformities. If present, place the ring (2) back into the J 41048 ensuring the swage ring (2) covers
the whole swaging area.
5.7.
Re-swage the swage ring (2).
