Grand Prix V6-3.8L (2007)
3. Using a thin walled socket, remove the screws (1) from the pull handle.
4. Beginning at the lower rear of the door, use J 38778 to disengage the trim panel from the rear door inner panel.
5. Lift the trim panel to disengage the channel at the top edge and to clear the door lock button.
6. If equipped, disconnect the electrical connector for the power window switch.
7. Remove the rear door trim panel from the vehicle.
Installation Procedure
1. If equipped, connect the electrical connector for the power window switch.
2. Position the trim panel to the rear door inner panel, verifying that the door handle comes through the bezel.
3. Install the rear door trim panel pressing until the retainers are fully seated.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the door trim retaining screws through the pull handle.
Tighten the screws to 3.5 N.m (31 lb in).
5. Install the cover plate to the armrest pull handle. Press firmly until the plate is seated.
Rear Side Door Warning Reflector Replacement
Rear Side Door Warning Reflector Replacement
Removal Procedure
