Grand Prix V6-3.8L (2007)
Sunroof / Moonroof Motor: Removal and Replacement
SUNROOF MOTOR/ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. IMPORTANT: The sunroof actuator drive shaft turns in both directions and contains no limit switches. The sunroof actuator may be replaced
with the window panel in any position.
Remove the headliner.
2. Remove the tie strap from the wiring harness.
3. Remove the screws from the sunroof motor/actuator (1).
4. Disconnect the electrical connector from the wiring harness.
5. Pull straight down to disengage the drive gear from the sunroof opening positioning switch (SOPS).
6. Remove the sunroof motor/actuator from the sunroof module.
INSTALLATION PROCEDURE
1. Position the sunroof motor/actuator to the sunroof module.
2. Connect the electrical connector to the wiring harness.
3. Push the sunroof motor/actuator straight in to engage its drive gear into the SOPS.
4. NOTE: Refer to Fastener Notice.
Install the sunroof motor/actuator screws (1) to the sunroof motor/actuator.
Tighten the sunroof motor/actuator screws to 3 N.m (27 lb in).