Grand Prix V6-3.8L (2007)
6.
Reinstall the wire seals into both halves of the connector body.
7.
Wipe away any lubricant that may have oozed out onto the outside of the connector.
8.
Seal the outside of the connector halves to prevent the reoccurrence of moisture or water.
^
If available, wrap the outside of each connector half with a *3M Scotch(R) Electrical Moisture Sealant Tape, P/N 06149. Each side of the
connector will require two patches to seal the connector halves and wires.
^
If the 3M product is not available, then wrap the outside of both connector halves and wires in black electrical tape.
9.
Reattach the connector to the strut (shock) tower.
10.
Using a Tech 2(R), clear the DTCs.
*We believe this source and their products to be reliable. There may be additional manufacturers of such products. General Motors does not
endorse, indicate any preference for or assume any responsibility for the products from this firm or for any such items which may be available
from other sources.
Parts Information
Warranty Information
Disclaimer
