Grand Prix V6-3.8L (2007)
7. Disconnect the EVAP pipe quick-connect fitting (3) at the fuel filter area.
Important: Use a back up wrench to prevent the fuel filter fitting from turning.
8. Remove the threaded nut fitting (1) from the outlet of the in-line fuel filter.
9. Cap the in-line fuel filter as needed to stop any fuel leakage.
Important: Note the position of the fuel feed, the EVAP purge pipe and the attaching hardware for installation.
10. Remove the fuel and the EVAP pipe clips from the pipes.
11. Remove the fuel feed and the EVAP pipes from the vehicle.
12. Inspect the pipes for bends, kinks and cracks.
Installation Procedure
Caution: In order to Reduce the Risk of Fire and Personal Injury: If nylon fuel pipes are nicked, scratched or damaged during installation,
they must be replaced.
Notice: Refer to Fuel System Ground Notice in Service Precautions.
Notice:
*
Secure the fuel pipes to the frame in order to prevent chafing. Maintain a minimum of 13 mm (1/2 inch) clearance around a pipe in order to
prevent contact and chafing. Maintain a minimum of 19 mm (3/4 inch) around any moving part.
