Grand Prix V6-3.8L (2007)
Fuel Pressure: Testing and Inspection
Fuel Pressure Gage Installation and Removal
Fuel Pressure Gage Installation and Removal
Tools Required
J 34730-1A Fuel Pressure Gage
Installation Procedure
Caution: Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or
diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.
1. Remove the fuel injector sight shield.
Caution: Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will
absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the
connection of the fuel pressure gage is complete.
Notice: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
*
The fuel pipe connections
*
The hose connections
*
The areas surrounding the connections
Install the J 34730-1A to the fuel pressure service connection, located on the fuel rail.
2. Turn ON the ignition.
Caution: Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an
explosion.
3. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
4. Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
5. Command the fuel pump ON with a scan tool.
6. Close the bleed valve on the fuel pressure gage.
7. Inspect for fuel leaks.
Removal Procedure
1. Place the fuel pressure gage bleed hose into an approved container. Open the bleed valve in order to bleed the fuel system pressure.
2. Place a shop towel under the fuel pressure gage in order to catch any remaining fuel spillage.
