Grand Prix V6-3.8L (2007)
the following situations:
*
The vehicle has completed a useful life.
*
Irreparable damage occurs to the vehicle in a non-deployment type accident.
*
Irreparable damage occurs to the vehicle during a theft.
*
The vehicle is being salvaged for parts to be used on a vehicle with a different VIN as opposed to rebuilding as the same VIN.
Caution: Refer to SIR Inflatable Module Deployment Outside Vehicle Caution.
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove all loose objects from the front seats.
5. Disable the SIR system. Refer to SIR Disabling and Enabling.
Caution: A deployed dual stage inflator module will look the same whether one or both stages were used, always assume a deployed dual
stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
6. Disconnect the steering wheel module yellow connector (1) from vehicle harness yellow connector (3).
Important: Vehicle is equipped with dual stage air bags the steering wheel module and I/P module will each have 4 wires. Refer to SIR
Connector End Views for determining high and low circuits.
7. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
8. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
9. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the driver deployment
harness.
10. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
11. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.
12. Twist together two connector wire leads (the high circuits from both stages of the steering wheel module) to one sets of deployment wires. Refer to
SIR Connector End Views in order to determine the correct circuits.
13. Inspect that the 3 wire connection is secure.
