Grand Prix V6-3.8L (2007)
Important: Vehicle is equipped with dual stage air bags the I/P module will each have 4 wires. Refer to SIR Connector End Views for
determining high and low circuits.
47. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
48. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
49. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the IP module
deployment harness.
50. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
51. Twist together one end from each of the wires in order to short the wires.
52. Twist together two connector wire leads (the high circuits from both stages of the steering wheel module) to one sets of deployment wires. Refer to
SIR Connector End Views in order to determine the correct circuits.
53. Inspect that the 3 wire connection is secure.
54. Bend flat the twisted connection.
