Grand Prix V6-3.8L (2007)
Rear Door Window Motor: Service and Repair
REAR SIDE DOOR WINDOW REGULATOR MOTOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the rear door trim panel.
2. Remove the rear door water deflector.
3. Raise the window far enough in order to gain access to the bolts (1) that attach the window to the regulator.
4. Remove the bolts (1) that attach the window to the regulator.
5. Raise the window to the full up position and tape in place.
6. Disconnect the electrical connector (2) from the power window motor by pulling out on the tab (1).
7. Remove the window regulator bolts in the specified sequence (1, 2, 3) from the inner door panel.
8. Remove the window regulator and motor through the access opening in the door panel.