Grand Prix V6-3.8L SC VIN 1 (1997)
Keyless Entry Transmitter: Service and Repair
Transmitter Programming
Transmitter Programming
In the event that a transmitter is lost, the "old" and "new" transmitter(s) will need to be programmed into the remote control door lock receiver's memory.
Up to four transmitters may be programmed.
Important
^
Once the keyless entry receiver enters the programming/diagnostic mode, the programming of the first transmitter erases all previous transmitter
programming information, requiring the programming of all transmitters.
^
Program only one vehicle remote control door lock receiver at a time. If multiple receivers are being programmed simultaneously, it is possible
that the same transmitter could be programmed to more than one remote control door lock receiver.
1. Sit in the vehicle driver's seat.
2. Remove the ignition key from the ignition lock cylinder.
3. Close all of the vehicle's doors.
4. Remove the "MALL PGM" fuse from the fuse panel.
5. Turn the ignition lock cylinder to the "ACC" position.
6. Turn the ignition lock cylinder to "OFF", then back to "ACC" within 1 second.
7. Open, then close any vehicle door. A chime will be heard when the remote control door lock receiver enters the programming/diagnostic mode. If
a chime is not heard, start again at step 1. If the programming/diagnostic mode is not entered after a second attempt.
8. Press and HOLD the transmitter "LOCK" and "UNLOCK" buttons simultaneously for 14 seconds.
Important
^
After 7 seconds, a chime may be heard confirming successful SYNCHRONIZATION. After approximately 14 seconds, a chime will be heard
on firming successful PROGRAMMING.
9. Repeat step 8 for each additional transmitter to be programmed.
10. Remove the ignition key from the ignition lock cylinder.
11. Install the "MALL PGM" fuse back into the fuse panel.
