Grand Prix V6-3.8L SC VIN 1 (1997)
Figure 26
Figure 27
Figure 28
21. Short the wires by twisting together one end of each (Figure 28). The deployment wires shall remain shorted and not connected to a power source
until you are ready to deploy the air bag.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed:
^
Wear safety glasses throughout the procedures.
^
Make sure the area around the inflator module is clear of all people and loose or flammable objects.
^
Short the deployment harness wires as instructed.
^
Connect the deployment harness to the inflator module before you connect it to the power source.
^
Connect the deployment harness to the power source to immediately deploy the air bag.
Failure to follow the procedures in the order listed may result in personal injury.
22. Twist together one connector wire lead to one deployment wire (1). The connection must be mechanically secure (Figure 29).
23. Bend flat the twisted connection that you made in the previous step. Secure the connection by wrapping tightly with electrical tape (2). This will
also insulate the connection (Figure 29).
24. Twist together, bend and tape the remaining connector wire lead to the remaining deployment wire (3) (Figure 29).
25. Connect the deployment harness to the inflatable restraint I/P module, yellow 2-way connector.
26. Route the deployment harness out the passenger side of the vehicle (Figure 30).
27. Be sure to clear the inside of the vehicle and the area surrounding the vehicle of any people. Clear the vehicle of all loose or flammable objects.
28. Stretch the driver and passenger deployment harnesses to their full length (Figures 26 and 30).
29. Completely cover windshield area and front door window openings with a drop cloth, blanket or similar item. This reduces the possibility of injury
due to possible fragmentation of the vehicle's glass or interior.
30. Notify everyone in the immediate area that you intend to deploy the air bags. The deployment will be very loud. This may startle any uninformed
people in the area.
31. Place a power source near the shorted end of the SIR Deployment Harness. Use a vehicle battery when available, but always use a power source
that complies to the following:
^
12 volts minimum.
^
2 amps minimum.
32. Separate the two ends of the driver deployment harness wires (Figure 31).
