Grand Prix V6-3.8L SC VIN 1 (1997)
REMOVE OR DISCONNECT
1. Dash side automatic transaxle range selector lever cable from the wiring harness clip.
2. Console.
3. Automatic transaxle range selector lever cable retaining clips and cable at console shift control.
4. Pull carpet back to expose the automatic transaxle range selector lever cable.
5. Automatic transaxle range selector lever cable through hole in cowl.
INSTALL OR CONNECT
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Properly route and position the automatic transaxle range selector lever cable.
2. Carpet into position.
3. Automatic transaxle range selector lever cable at console and retaining clips.
4. Console.
5. Dash side automatic transaxle range selector lever cable to the wiring harness clip.
Column Shift, Transaxle Range Selector Lever Cable End
