Grand Prix V6-3.8L SC VIN 1 (1997)
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Insert the automatic transaxle range selector lever cable thru the dash from the engine compartment side.
2. Automatic transaxle range selector lever cable to automatic transaxle range selector lever cable bracket.
3. Automatic transaxle range selector lever cable to automatic transaxle range selector lever.
4. Automatic transaxle range selector lever cable to wiring harness clip or strap.
5. Air cleaner duct. Refer to POWERTRAIN MANAGEMENT.
6. Automatic transaxle range selector lever cable to.
-
Shift control.
-
Column.
Adjust
-
Transaxle side automatic transaxle range selector lever cable.
Transaxle Range Selector Lever Cable Installation (New Only)
CAUTION: The automatic transaxle range selector lever cable is made out of two cable sections. After initial connection, never separate the
two metal couplings from one another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal
couplings occurs. When servicing the transaxle, remove the cable at the automatic transaxle range selector lever and automatic transaxle range
selector lever cable bracket. If either section of the cable needs to be replaced, replace both cable sections. Loss of connection integrity of the
two metal couplings can cause loss of transaxle shift control which could result in personal injury.
