Grand Prix V6-3.8L VIN 2 (2004)
Rear Door Window Motor: Service and Repair
Window Regulator Motor Replacement - Rear Door
Removal Procedure
1. Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door See: Rear Door Panel/Service and Repair
2. Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear Door (See: Rear Door Panel/Service and Repair) .
3. Raise the window far enough in order to gain access to the bolts (1) that attach the window to the regulator.
4. Remove the bolts (1) that attach the window to the regulator.
5. Raise the window to the full up position and tape in place.
6. Disconnect the electrical connector (2) from the power window motor by pulling out on the tab (1).
7. Remove the window regulator bolts in the specified sequence (1, 2, 3) from the inner door panel.
8. Remove the window regulator and motor through the access opening in the door panel.