Grand Prix V6-3.8L VIN 2 (2004)
2. install BPMV (2) and EBCM as an assembly into the BPMV bracket. Align the flats of the studs on the BPMV with the BPMV bracket.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
3. Install the 2 BPMV to BPMV bracket nuts (1).
*
Tighten the 2 BPMV to BPMV bracket nuts to 12 Nm (8 ft. lbs.).
Caution:
Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel
lockup will occur and personal injury may result The only two ways this condition can be detected are by using a Scan Tool or by
doing an Antilock stop.
Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings in the compartment during the next step.
Important: Use the locations noted during removal.
4. Install the master cylinder brake pipes (1) on the BPMV (2).
5. Install the wheel cylinder brake pipes (1) on the BPMV (2).
*
Tighten all of the brake pipe fittings to 15 Nm (11 ft. lbs.).
