Grand Prix V6-3.8L VIN 2 (2004)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Removal Procedure
Caution:
Refer to Brake Fluid Irritant in Service Precautions.
See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Caution
Notice:
Refer to Brake Fluid Effects on Paint and Electrical Components in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Brake Fluid Effects on Paint and Electrical Components Notice
Notice:
To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON
position.
1. Turn the ignition switch to the OFF position.
2. Remove the fuel injector sight shield, 3.8L engine only. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield
Replacement (L32) in Engine Mechanical - 3.8L.
3. Remove the front fender upper diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
4. Disconnect the accelerator and cruise control cable from the accelerator control cable bracket.
5. Disconnect the cruise control module from the left strut tower. It is not necessary to remove the cable from the module. Position the module and
cables aside.
6. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.8L.
7. Disengage the locking tab (1) from the EBCM harness connector.
8. Disconnect the EBCM harness connector.
9. Remove any dirt/debris from the assembly.
10. Remove the 6 EBCM to BPMV retaining bolt/screws.
Important: Do not pry apart using a tool. Be careful not to damage BPMV surface.