Grand Prix V6-3.8L VIN 2 (2004)
1. Position the engine mount bracket to the engine.
2. Connect the knock sensor harness connector and install the shield.
3. Install the rear engine mount bracket bolts to the engine. Hand tighten the bolts at this time.
4. Install the front engine mount bracket bolts to the engine. Hand tighten the bolts at this time.
Notice: Refer to Fastener Notice in Service Precautions
5. Tighten the engine mount bracket bolts.
^
Tighten the bolts to 102 Nm (75 ft. lbs.).
6. Install the engine mount.
7. Install the A/C compressor to the engine.
8. Install the drive belt.
9. Install the transmission.
