Grand Prix V6-3.8L VIN 2 (2004)
3. Install the I/P carrier to the vehicle. Align the I/P carrier to the HVAC module and the hinge pillars.
4. Install the bolts to the right and the left I/P carrier.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
5. Install the bolts to the HVAC module upper support bracket.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
6. Install the bolts to the HVAC module center support bracket.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
7. Position the I/P wiring harness to the original position.
8. Connect any disconnected ground wires.
9. Install the BCM.
10. Install the brake pedal brace bolts to the I/P carrier.
11. Install the brake pedal.
12. Install the booster push rod to the brake pedal.
13. Seat the bottom junction block tabs and snap the top of the junction block to the passenger knee bolster.
14. Install the junction block bolt.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
15. Install the RH side air duct.
16. Install the RH side air duct screws.
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
17. Install the LH side air duct.
18. Install the LH side air duct screws.
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
