Grand Prix V6-3.8L VIN 2 (2004)
3. Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle.
4. Confirm the number of threads showing on each tie rod end is nearly equal.
Notice: Refer to Fastener Notice in Service Precautions.
5. Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).
Tighten the jam nut at the tie rod ends to 68 Nm (50 ft. lbs.).
Important: Ensure the seals do not twist.
6. Install the seal clamps.
Rear Camber Adjustment
Removal Procedure
1. Raise the vehicle and provide suitable support. Refer to Vehicle Lifting.
2. Remove the tire and wheel assemblies.
3. Remove the strut from the vehicle.
4. Place the strut in a vise and file the upper strut-to-knuckle hole lateral (oblong). Compare the appearance of the holes before filing (2) with after
filing (3).
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the strut to the vehicle.
Tighten the strut-to-knuckle nuts as far as to allow movement of the knuckle.
2. Install the tire and wheel assemblies.
