Grand Prix V6-3.8L VIN 2 (2004)
7.3.
Remove the BEC housing (1) from the vehicle.
INSTALLATION PROCEDURE
1. If the BEC housing was removed, perform the following:
1.1.
Position the BEC housing (1) to the strut tower and insert the lower tab into the slot on the tower.
NOTE: Refer to Fastener Notice in Service Precautions.
1.2.
Install the BEC housing nuts (2) to the studs on the strut tower.
Tighten
Tighten the nuts to 3 N.m (27 lb. in).
2. Connect the wiring harness connectors to the junction block.
