Grand Prix V6-3.8L VIN 2 (2004)
9. Remove the connector position assurance (CPA) (4) and the electrical connectors from the driver inflator module.
10. Remove the horn grounded lead (2) from the threaded hole in the steering wheel.
11. Rotate the horn contact lead counterclockwise 1/4 turn.
12. Remove the horn contact lead (2) from the steering column cam tower.
13. Remove the inflatable restraint steering wheel module (5).
14. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Connect the horn ground lead (2) into the lower left threaded hole in the steering wheel.
2. Connect the horn contact lead into the steering column cam tower.
3. Rotate the horn contact turn 1/4 turn clockwise to lock.
4. Connect the inflator module electrical connectors and CPA (4).
IMPORTANT: Route the driver inflator wires, the redundant control wires, and the horn wires correctly.
5. Align the driver inflator module fasteners to the steering column fastener holes.
6. Push the driver inflator module firmly into the steering column to engage the fasteners.
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
