Grand Prix V6-3.8L VIN 2 (2004)
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Position the inflatable restraint side impact sensor by the door.
3. Connect the side impact sensor connector (4).
4. Install the CPA (3) to the side impact sensor connector (4).
5. Install the side impact sensor (1) to the door (4).
NOTE: Refer to Fastener Notice in Service Precautions.
6. Align the locating pin on the sensor (1) to the opening in the door (4).
Begin tightening the side impact sensor bolts (2).
Tighten
Tighten the bolts to 10 N.m (89 lb in).
7. Install the water deflector to the door.
8. Install the door trim panel.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2, or SIR Disabling and Enabling Zone 6.
