Grand Prix V6-3.8L VIN 2 (2004)
1. Install the new swage ring (2) on the neck of the outboard seal (1). Do not swage.
2. Slide the outboard seal (1) onto the halfshaft bar and position the neck of the outboard seal (1) in the seal groove on the halfshaft bar. The largest
groove below the sight groove on the halfshaft bar is the seal groove (3).
3. The swage ring is swaged using J41048 by the following method:
3.1.
Position the outboard end of the halfshaft assembly (1) in J41048.
3.2.
Align the swage ring.
3.3.
Place the top half of J41048 on the lower half of J41048.
Important: Align the following items during this procedure:
-
The outboard seal (1)
-
The halfshaft
-
The swage ring
Notice: Refer to Fastener Notice in Service Precautions.
3.4.
Insert the bolts (2) and tighten by hand until snug.
Each bolt 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
