Grand Prix V6-3.8L VIN K (1998)
Power Window Motor: Service and Repair
Power Window Switch
POWER WINDOW SWITCH
Rear Door - Sedan
REMOVAL PROCEDURE
IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of
shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
IMPORTANT: Use protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur if it is not
protected.
1. Use a flat-bladed tool in order to remove the power window and door lock switch plate assembly (1) from the trim panel.
2. Insert the tool at the rear of the switch plate (1). Press forward in order to release the switch plate retainers.
3. Remove the switch from the mounting plate.
4. Disconnect the electrical connector.
5. Remove the switch from the mounting plate.
INSTALLATION PROCEDURE
