Grand Prix V6-3100 3.1L MFI VIN M (1994)
3. Cable support bracket (with cable attached) with bolt and washer. Tighten bolt to 43 Nm (32 lb ft).
4. End of parking brake cable to parking brake lever if disconnected. Lift up on end of cable spring clip and work end of parking brake cable into
notch in lever.
5. Brake hose to caliper if disconnected. Bleed brakes if brake hose was disconnected.
6. Remove wheel nuts securing rotor to hub. Install wheels and tires, aligning previous marks.
7. Lower vehicle.
8. Apply approximately 778 N (175 lb) force to brake pedal (after bleeding, if necessary) three times to seat pads against rotor.
Disassemble/Assemble
Disassemble
1. Caliper completely from vehicle.
2. Piston assembly using low pressure compressed air into the caliper inlet hole. Piston will come out through piston boots.
WARNING: Do not place fingers in front of the piston in an attempt to catch or protect it when applying compressed air. This could
result in serious injury.
CAUTION: Pad interior of caliper assembly with clean shop towels to prevent damage to piston assembly as it is removed.
