Grand Prix V6-3100 3.1L MFI VIN M (1994)
be visually identified by the modification made to the lens as shown in Figure 6.
Until the new service only replacement tail lamps are available, use the following complete procedure when installing the new "production" tail lamp
assembly part numbers listed below. When the new "service only" replacement tail lamp assembly becomes available, this same procedure, with the
exception of Step # 8, should be followed.
Parts Required
^
Clear Auto Body Sealant, 3M Ultrapro # 08302 (or equivalent) (The 3M Ultrapro # 08302 Clear Auto Body Sealant is a 5 oz. tube, which when used
as instructed, can seal at least two tail lamp assemblies).
^
Production Replacement Tail Lamp Assembly:
P/N 5977913 (Left)
P/N 5977914 (Right)
^
Four to six flat washers, (1/4 I.D. by 3/4 O.D.) for shimming the tail lamp assembly to the body.
Procedure
1.
Obtain a new tail lamp assembly.
