Grand Prix V6-3100 3.1L MFI VIN M (1994)
REMOVAL:
1.
Remove the lower instrument panel trim screws, retaining clip and lower instrument panel trim.
2.
Remove the accelerator cable from the accelerator pedal.
3.
Squeeze the accelerator cable cover tangs and push the cable through the dash panel (bulkhead).
4.
Remove cable from restraints and throttle body bracket.
5.
Remove cable.
INSTALLATION:
NOTE: To prevent possible interference, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2") of moving parts,
unless routing is positively controlled by restraint clips or ties.
1.
Reverse the removal procedure.
^
Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the
accelerator pedal. The throttle should operate freely without binding between full closed and wide open throttle.
2.
Apply a heavy bodied sealer around the accelerator cable at the engine compartment side of the dash panel (bulkhead).
