Grand Prix V6-3100 3.1L MFI VIN M (1994)
CAUTION: Safety glasses must be worn when using compressed air, as flying dirt particles may cause eye injury.
2. Using compressed air, blow dirt out of fitting.
3. Squeeze plastic retainer release tabs.
4. Pull connection apart.
For Metal Fitting
1. Grasp both sides of fitting. Twist female connector 1/4 turn in each direction to loosen any dirt within fitting.
CAUTION: Safety glasses must be worn when using compressed air, as flying dirt particles may cause eye injury.
2. Using compressed air, blow dirt out of fitting.
3. Choose correct tool from J 37088-A or J 39504 tool set for size of fitting. Insert tool into female connector, then push/pull inward to release
locking tabs.
4. Pull connection apart.
Clean and Inspect
NOTICE: If it is necessary to remove rust or burrs from fuel pipe: use emery cloth in a radial motion with the pipe end to prevent damage to
0-ring sealing surface.
^
Using a clean shop towel, wipe off male pipe end.
^
Inspect both ends of fitting for dirt and burrs. Clean or replace components/assemblies as required.
Install or Connect
CAUTION: To Reduce the Risk of Fire and Personal Injury: Before connecting fitting, always apply a few drops of clean engine oil to the male pipe
end. This will ensure proper reconnection and prevent a possible fuel leak.
(During normal operation, the 0-rings locate in the female connector will swell and may prevent proper reconnection if not lubricated.)
1. Apply a few drops of clean engine oil to the male pipe end.
2. Push both sides of fitting together to cause the retaining tabs/fingers to snap into place.
3. Once installed, pull on both sides of fitting to make sure connection is secure.
