Grand Prix V6-3100 3.1L MFI VIN M (1994)
5.
Install NEW SWRC wire harness and original switches removed in Step 3, and route Yellow & Gray SIR coil wires as shown in Figure 2. Make
sure wires are in groove (formed in step 4), below surface and away from any sharp edges. Be sure to use a blunt object such as a tongue depressor
or Popsicle stick to install wires.
6.
Reinstall SIR module and enable SIR system.
7.
Clear codes from SIR system. Perform SIR System Diagnostic Check.
8.
Verify correct operation of redundant controls and control backlighting. Any malfunctions should be corrected and the system rechecked.
9.
Install Campaign Identification Label.
Coil Replacement Procedure
1.
Obtain THEFTLOCK code from customer.
2.
Disconnect negative battery cable.
3.
Remove steering wheel.
4.
Remove steering wheel redundant control/supplemental inflatable restraint coil following applicable Service Manual instructions. Coil WILL NOT
be reused.
5.
Install NEW steering wheel redundant control/supplemental inflatable restraint coil following applicable Service Manual instructions.
6.
Reinstall steering wheel.
7.
Reconnect negative battery cable.
