Grand Prix V6-3100 3.1L MFI VIN M (1994)
4.
Using bedding and glazing compound, run a 5 mm bead around entire inboard edge of the retainer (See Figure 4, View B). Using bedding
and glazing compound, fill the cavity in the upper front corner of the rear door and the upper rear corner of the door.
5.
Spray the window run channel with glass cleaner for ease of installation.
6.
Reinstall the window run channel using a plastic trim stick to insure that the run channel is fully seated in the retainer.
Labor Operation
Labor Time
C0340 (Right), C0341 (Left)
0.3 hr (Each)
There should be a medium amount of resistance as the bill or paper is slowly withdrawn. Continue around the entire seal area. If there is little or no
resistance, it indicates there is insufficient contact to form a good seal. This test may indicate that the door is out of alignment, adjust as necessary.
VII. Windnoise around mirror.
1.
Remove the mirror per Section 10 of the Service Manual.
