pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

3T40 Automatic Transaxle|Page 6255 > < 3T40 Automatic Transaxle|Page 6253
Page 2
background image

REMOVE OR DISCONNECT

1. Air cleaner.
2. Crossover pipe.
3. Shift cable Clip at lever and mount bracket.
4. Install J 28467-A, J 28467-90 and J 36462.
5. Raise vehicle and suitably support.
6. Left front wheel. 
7. Left inner fender splash shield.
8. Transaxle mount. Refer to "Transaxle Mount".
9. Loosen engine mount nuts at frame.

CAUTION:  Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or
intermediate shaft. This damage may cause loss of steering control which could result in personal injury.

10. Pinch bolt at intermediate steering shaft.
11. Ball joints at steering knuckle.
12. Support right and left sides of frame with jackstands.
13. Left side frame to body bolts/screws.
14. Loosen right side frame to body bolts/screws.
15. Left side steering rack bolt/screw.
16. Wiring hamess.
17. Left drive axle.
18. Transaxle mount bracket. Refer to "Transaxle Mount".
19. Position drain pan under transaxle.
20. Bolts/screws and nuts.
21. Case side cover pan and gasket.

CLEAN

^

Case and side cover gasket surfaces.

INSTALL OR CONNECT

1. Case side cover pan and gasket.
2. Bolts/screws and nuts.

TIGHTEN

^

Bolts/screws to 11 Nm (97 lb. in.).

^

Nuts to 8 Nm (71 lb. in.).

3. Transaxle mount bracket. Refer to "Transaxle Mount".
4. Left drive axle.
5. Wiring harness.
6. Left side steering rack bolt/screw.
7. Frame to body bolts/screws.
8. Remove support from frame.
9. Ball joints at steering knuckle.

CAUTION:  When installing the Intermediate shaft make sure the shaft is seated prior to pinch bolt Installation. If the pinch bolt is inserted
into the coupling before shaft installation, the two mating shafts may disengage.

10. Pinch bolt at intermediate steering shaft.
11. Engine mount at frame.
12. Transaxle mount. Refer to "Transaxle Mount".
13. Left inner fender splash shield.
14. Left front wheel.
15. Lower vehicle.
16. Remove J 28467-A, J 28467-90 and J 36462.
17. Shift cable clip at lever and mount bracket.
18. Crossover pipe.
19. Air cleaner.

Transaxle Mount

TRANSAXLE MOUNT

3T40 Automatic Transaxle|Page 6255 > < 3T40 Automatic Transaxle|Page 6253